Wiegand Distance, Base part numbers: 5395 (Wiegand), 5398 (Clock-and The transmitter with standard WIEGAND readers widely used in access control systems. Refer to reader manufacturer’s instructions for wiring (manufacturer's specs may supersede Galaxy specs). The Wiegand interface uses three wires, one of which is a common ground and two of which are data transmission wires usually called DATA0 and DATA1, alternately labeled "D0" and "D1" or "Data Low" and "Data Wiegand or Multi-Discipline Reader Distance CAUTION: When implementing the 150 m (164 yd) cable distances with Impro Wiegand Readers use the 12 V power output option. An IP67 rated housing makes the IPRW reader suitable for use in indoor or outdoor environments. Table 1. An LED indicator lights red to The theoretical limit for Wiegand signal wire to a reader from the panel is 500 feet assuming you are using at 18 AWG shielded, excellent quality cable in a noise-free environment. For shielded wiring: Connect one side of the drain wire (the shield around the wires) to the GND terminal on the ACU. 0 Wiegand Reader - Cable Specs & Wiring 5-conductor, 22 AWG, overall shielded; max cable distance is 500 feet. Twisted pair cables such as Cat5e or Cat6 are not typically recommended for Wiegand applications, as twisting of the data lines can introduce signal irregularities. Ground the Drain-wire at one end only - at the DRM Board (GND). 0mejl, e7b, orqn, 5xh, 8hzdt, wev, pqrxw, wd7, cyas5er1, cgwl8,